AutoGlossy


AutoGlossy - Articles

Let's Get A Cup Of Coffee--It Will Work After That!

Maryland Auto Transport

When I first started doing mechanic work in 1970 (we weren’t known as *technicians* then) I learned a great *trick-of-the-trade*.

My boss and I were replacing the clutch on this 1969 Chevy pickup.

After he had put the line-up shaft through the clutch plate to get it lined up, so the transmission shaft would go through it, we bolted the pressure plate up to the flywheel.

I pushed the jack, with the transmission on it, up to the back of the engine.

The transmission still had the bell-housing on it.

My boss was at the back of the engine. He guided the bell-housing up to the engine block.

We were very lucky; the transmission went right up to the block.

Well, almost.

It would not go the last ½ inch.

We put a couple of bolts in and tried to draw it up, but it was in a bind.

Removing the bolts so we could *shake* the transmission; sometimes this will cause it to line up with the pilot bearing.

We pushed up and down, right and left. The transmission was off the jack but we left the jack there so we could set the transmission back down on it and rest our arms.

We tried several times, and for several minutes (2 days to be exact, I think), but the transmission just wouldn’t go in that last half inch.

My boss had a large amount of tobacco in his mouth. He motioned for me to rest, spit a long stream of juice toward the left front tire, and said, “Let’s go get a cup of coffee.”

He was the boss, who was I to complain? :-)

When we returned from the café he said, “Now it will go in.”

I thought… no, I won’t say what I thought.

We returned to our creepers, slid back under the truck.

He took the tail of the transmission and raised it up just a little bit and pushed the transmission all the way up to the block.

“Now put the bolts in.” he said with a silly grin.

“What did you do!?” I asked.

“Nothing, we were just too tired to get it lined up. That’s why we got a cup of coffee…to rest up.”

Well, throughout the years, I’ve never forgotten that, and I’ve used that technique several times.

I’m not sure if I stopped working on a project to rest up or just show the vehicle that I’m smarter than it is. 

Resources:

Related articles:

Car Insurance Online Quotes - No Fuss
There are many ways to shop for car insurance but getting car insurance online quotes has got to be one of the easiest ways to shop for it. A car insurance online quote has many advantages such as you
2005-09-17 - by Peter Crump

Brake Dust Shields Protect Your Wheels
The quickest way to ruin the wheels on your car is to let brake dust gather unimpeded. Sure, you can clean the dust off on a daily basis, but who has the time? What if you ruin them by using an abra
2005-09-17 - by Matthew Keegan

How to Finish that Classic Car Project
How many classic car projects can be completed these days? The old time junkyard itself is becoming obsolete. Many yards are being crushed or have been picked over so much there is nothing left to cho
2005-09-17 - by Cynthia Arrington

When Fuel Pumps Give Up The Ghost
Cruising down the highway at 70mph in your ‘98 Bimmer you notice a strange sound coming from somewhere underneath your car. You proceed down the road a few more miles before exiting and making the tur
2005-09-17 - by Matthew Keegan

Get To Know Auto Insurance California Style
When purchasing auto insurance, California has some stipulations regarding the coverage of its drivers. The purpose of this, of course, is that everyone is expected to be responsible in a case of an a
2005-09-17 - by Peter Crump


    Copyright © 2005 Autoglossy.com
© 2005 Autoglossy.com